Thursday, August 8, 2013

Tracing using TRACERT

With the TRACERT command we can determine the entire path ICMP echo request transfer between source computers to his destination. The path will show us all the pints the ICMP pass until him rich his destination

Syntax

Tracert [-switch] [Target Name]

Parameters

-d: with this switch we cause the command to prevent resolving the IP addresses. We chose this switch when you want to achieve faster results.

-h maximum Hops: here we can chose the HOPS numbers sending to each point between the Source and the Destination.

Target name: Here we need to specify the destination we want to check.

Example:

C:\Users\3>tracert www.microsoft.com

 Tracing route to lb1.www.ms.akadns.net [207.46.19.254]

over a maximum of 30 hops:

   1     1 ms    <1 ms    <1 ms  SL2141.siemens [10.0.0.138]
  2    15 ms    15 ms    17 ms  bzq-79-179-197-1.red.bezeqint.net

  3     *       16 ms     *     www.microsoft.com [207.46.19.254]

  4     *        *     1773 ms  www.microsoft.com [207.46.19.254]

  5    19 ms    18 ms    18 ms  www.microsoft.com [207.46.19.254]

  6     *        *     3670 ms  www.microsoft.com [207.46.19.254]

  7    97 ms    96 ms    96 ms  www.microsoft.com [207.46.19.254]

  8    96 ms    97 ms    96 ms  www.microsoft.com [207.46.19.254]

  9   168 ms   168 ms   166 ms  www.microsoft.com [207.46.19.254]

 10   171 ms   176 ms   172 ms  www.microsoft.com [207.46.19.254]

 11   205 ms   171 ms   171 ms  www.microsoft.com [207.46.19.254]

 12     *        *        *     Request timed out.

 13     *        *        *     Request timed out.

 14     *        *        *     Request timed out.

 15     *        *        *     Request timed out.

 16     *        *        *     Request timed out.


Trace complete

 

No comments:

Post a Comment

My Presentations